Has anyone put W3 10's in a ext cab
#22
dual 4 ohms will wire down in series to 2OHM and you'll be fine on that 500/1 they are 4 and 2 ohm stable at 500 watts from my knowledge
500/1 specs:
http://mobile.jlaudio.com/products_amps.php?amp_id=439
250/1 specs:
http://mobile.jlaudio.com/products_amps.php?amp_id=435
500/1 specs:
http://mobile.jlaudio.com/products_amps.php?amp_id=439
250/1 specs:
http://mobile.jlaudio.com/products_amps.php?amp_id=435
#24
AcrophobiA
#26
Senior Member
Thread Starter
Thank you Joe!
I just installed the box/JL10W3 speaker and 500w Alpine mono block. Holy Cow it sounds incedible. I went off your advice and it is perfect exp I need to replace the door speakers now LOL
I just installed the box/JL10W3 speaker and 500w Alpine mono block. Holy Cow it sounds incedible. I went off your advice and it is perfect exp I need to replace the door speakers now LOL
#27
Good to hear that your happy with your set up.
I just started making the Ford sub boxes again this week.
My molding machine that makes the plastic caps for the top and side was down for about two weeks. Cost $3,000 to get a technician to fly in and fix it. Took him about two hours to find out that a bad solenoid was shorting out the controller.
I just started making the Ford sub boxes again this week.
My molding machine that makes the plastic caps for the top and side was down for about two weeks. Cost $3,000 to get a technician to fly in and fix it. Took him about two hours to find out that a bad solenoid was shorting out the controller.
#30
Senior Member
Thread Starter
my seat is exactly where the factory put it. Joes box was tight getting it in there but it's there with only mod done to my truck is the amp is mounted behind the passenger side rear seat