Dual door speaker install in front.
#1
Dual door speaker install in front.
Has anyone heard of or have advice on installing dual door speakers in the late model F150s? Mine is a 2010 CC and I am looking to put 2x 4 ohm 5.25 or 6.5 units wired in series so I can parallel both doors just before the amp and then bridge the channel to achieve 400 watts @4ohms. The reason, I want sound quality and loudness combined. What I dont want is to change the look of the door panel as I dont want anyone to be able to tell by looking.
I am not looking for recommendations on speakers or amps or wiring but rather the actual installation of dual door speakers and if it can be done as mentioned.
Thanks.
I am not looking for recommendations on speakers or amps or wiring but rather the actual installation of dual door speakers and if it can be done as mentioned.
Thanks.
#2
Senior Member
iTrader: (1)
Has anyone heard of or have advice on installing dual door speakers in the late model F150s? Mine is a 2010 CC and I am looking to put 2x 4 ohm 5.25 or 6.5 units wired in series so I can parallel both doors just before the amp and then bridge the channel to achieve 400 watts @4ohms. The reason, I want sound quality and loudness combined. What I dont want is to change the look of the door panel as I dont want anyone to be able to tell by looking.
I am not looking for recommendations on speakers or amps or wiring but rather the actual installation of dual door speakers and if it can be done as mentioned.
Thanks.
I am not looking for recommendations on speakers or amps or wiring but rather the actual installation of dual door speakers and if it can be done as mentioned.
Thanks.
#3
Loudness and SQ. Its dang near impossible to find GOOD 8 Ohm 200+ RMS watt car speakers or even 2 Ohm at that RMS 6.5" and below but easy to find 125 RMS in 4 Ohm. The very few that are out there are fudging their numbers. I am planning on going with CDT Audio speakers as they are high quality tight mids without the fluff and fudging. I am currently running POLK db5251, have tried MM and DB and want more.
#4
Senior Member
iTrader: (1)
Loudness and SQ. Its dang near impossible to find GOOD 8 Ohm 200+ RMS watt car speakers or even 2 Ohm at that RMS 6.5" and below but easy to find 125 RMS in 4 Ohm. The very few that are out there are fudging their numbers. I am planning on going with CDT Audio speakers as they are high quality tight mids without the fluff and fudging. I am currently running POLK db5251, have tried MM and DB and want more.
#5
Ive got a good class d 4 channel amp and will run good speakers @4 ohm so I'll effectively have 4 speakers at 100 rms in front (as opposed to 2 currently at 100rms) and 2 in the rear at 100rms and already have my sub too.
I'm thinking 4 speakers at 100rms each in front at 4 ohms should sound pretty dang good and since I'm not going to 2 ohm I wont lose my sq either.
So to sum up: I have 2 in front and 2 in rear each on my class d 4 channel at 4 ohms and each set at 100rms, amp will do 125rms and a sub at 400 watts on a seperate class d mono amp. I have good sq and loudness but want more loudness while keeping sq.
I would like to change it to 4x 100rms up front at 4 ohms and leave the remaning alone thus I now have 600 watts of mids and highs. To achieve this I will wire 2 in each door in series to get 8 ohms, next I will put them in parellel just b4 the amp to get 4 ohms and bridge the front channel at which point the amp will now supply 400 watts to 4 speakers equating to 100 each.
Where is my logic failing?
#7
Here you go:
http://www.diycable.com/main/product...roducts_id=538
This should outdisplace a pair of whatever you plan on running.
SQ + loudness.
http://www.diycable.com/main/product...roducts_id=538
This should outdisplace a pair of whatever you plan on running.
SQ + loudness.
Last edited by Ray21; 04-04-2013 at 10:00 PM.
The following users liked this post:
Richard75013 (04-05-2013)
Trending Topics
#8
Here you go:
http://www.diycable.com/main/product...roducts_id=538
This should outdisplace a pair of whatever you plan on running.
SQ + loudness.
http://www.diycable.com/main/product...roducts_id=538
This should outdisplace a pair of whatever you plan on running.
SQ + loudness.
Does anyone have any info on duals in the front doors tho?
#9
no not many do that cause of cancellation of the speakers your not going to hear those 2 any more than the one.. do some componets in your truck you will be happy.. i have boston pro componets n my truck love them