drivers door wiring questions
#1
Senior Member
Thread Starter
Join Date: Mar 2010
Location: Des Moines, IA
Posts: 103
Likes: 0
Received 0 Likes
on
0 Posts
drivers door wiring questions
I am having a problem with wiring my aftermarket speakers in my driver's door. on the passenger side I drilled out the molex and ran the wires through that however on the driver's door the molex is completely full and there's no room for aftermarket wiring, unless I move some pinsaround. not sure I want to mess with that .
how have you guys ran your aftermarket wiring from your speakers to your amplifiers on your driver's door.
Thanks
how have you guys ran your aftermarket wiring from your speakers to your amplifiers on your driver's door.
Thanks
#2
I managed to fed 4 separate strands of 12 gauge through that molex, it only took me 2-3 hours. I drilled a small pilot hole and then used progressively larger bits until it slid through with some wd40. If I remember correctly I drill one larger hole at the very top that fit 2 strands through and the other 2 were through just a single empty spot. I found it's a lot easier if you completely remove the ebrake during the install