brandon2708

I have 2 12 inch Memphis C3s 4 ohm dvc. They are 600w rms each. I bought a Rockford fosgate t1500-1bd to power them but I am afraid it will be too much power. Birth sheet says 1800 watts at 1 ohm which is what I would be running it at. I need to know if anyone has experience with these subs and if they can handle the power. Thanks.

GATORB8

May want to try asking at an SPL forum like: www.realmofexcursion.com/

Elderban

Just looking at the specs of the two, I would say that it's a little overkill.

idriveanevo

thats still not more than the max they handle, just turn the amp down a bit and you wont be pushing the entire 1800w.

mad4002

they will be fine the only way you would get all 1800w is if you have a high output alt because that rated 1800w was tested at 14.4v and if you dont have a HO alt you will never keep 14.4v and then on top of that you can factor in box rise which is the rise of independence of the subs at a frequency so in theory say at 45hz the box rise makes the subs act like they are setup to run 3 or 4ohms so much less power would be going to them