Did stereo shop hook up my two 2ohm svc subs and mono amp right??
#41
Senior Member
iTrader: (2)
The level is the gain. It should match the preamp outputs of your head unit, likely 4v.
Phase at 0
The remote "boost" is now going to act like the gain. Start out with it all the way down, then start turning it up.
Bass EQ will turn up an equalizer at 45hz. I'd leave it at 1 or 2.
Sub sonic: 3/4 up. 20-25hz
Low pass: it would be nice if it mached your 4chan amp. 140hz is straight up, I'd back it off a bit. This setting depends on your tast in music.
When you're truck is running the alternator puts out 14v
Phase at 0
The remote "boost" is now going to act like the gain. Start out with it all the way down, then start turning it up.
Bass EQ will turn up an equalizer at 45hz. I'd leave it at 1 or 2.
Sub sonic: 3/4 up. 20-25hz
Low pass: it would be nice if it mached your 4chan amp. 140hz is straight up, I'd back it off a bit. This setting depends on your tast in music.
When you're truck is running the alternator puts out 14v
I would assuming this will be from 1/2 to 3/4 when you are done tuning.
Everything else sounds good.
The think the bass eq/bass boost is set around 40hz. with the possible 0-10db's.
And in a perfect world, you alt will run @14V+. With headlamps and other accesories running, I would assume 13.6 or so
The following users liked this post:
Droop408 (03-20-2013)