Wyo11Scab

iTrader: (1)

To all you gurus out there.

Would it be possible to cut the input and output ends off a FRD-24 and splice the 70-5524 and 71-5524 to it so that it could be used on the 2013-14 models?
Wiring schematic of the FRD-24 is below.

WIRE AND TERMINAL IDENTIFICATION
Output of the OEM-1, 16 pin connector (cable “B” or AMP-RCA). Looking into connector / wire side of cable.
WIRE COLOR CIRCUIT CIRCUIT WIRE COLOR
ORANGE ILLUMINATION 8 16 IGNITION SWITCH 12V RED
BLUE/WHITE AMP TRIGGER 7 15 BATTERY YELLOW
BLACK GROUND 6 14 POWER ANTENNA BLUE
PURPLE/ BLK RIGHT REAR (-) 5 13 RIGHT REAR (+) PURPLE
GREEN/ BLACK LEFT REAR (-) 4 12 LEFT REAR (+) GREEN
N/C 3 11 N/C
GRAY/ BLACK RIGHT FRONT (-) 2 10 RIGHT FRONT (+) GRAY
WHITE/ BLACK LEFT FRONT (-) 1 9 LEFT FRONT (+) WHITE

Input of the OEM-1, 18 pin connector (cable “A” or “C”). Looking into connector / wire side of cable.
WIRE COLOR CIRCUIT CIRCUIT WIRE COLOR
WHITE/ BLK LEFT FRONT (-) 9 18 LEFT FRONT LOW LEVEL (+) WHITE/ RED
GRAY/ BLK RIGHT FRONT (-) 8 17 LEFT FRONT HIGH LEVEL (+) WHITE
GREEN/ BLK LEFT REAR (-) 7 16 RIGHT FRONT LOW LEVEL (+) GRAY/ RED
PURPLE/ BLK RIGHT REAR (-) 6 15 RIGHT FRONT HIGH LEVEL (+) GRAY
BLACK GROUND 5 14 LEFT REAR LOW LEVEL (+) GREEN/ RED
BLUE POWER ANTENNA 4 13 LEFT REAR HIGH LEVEL (+) GREEN
ORANGE ILLUMINATION/ DIMMER 3 12 RIGHT REAR LOW LEVEL (+) PURPLE/ RED
BLUE/WHITE AMP TRIGGER 2 11 RIGHT REAR HIGH LEVEL (+) PURPLE
RED IGNITION/ SWITCHED 1 10 BATTERY YELLOW

king nothing

Interesting idea. I bet it would work, although it would be an expensive alternative having to buy 3 harnesses it would save you work from having to build your harness from scratch

Wyo11Scab

iTrader: (1)

About $60. Looking for a way to have the amp turn on wire also without an add a fuse. Other concern is if the wires would all match.