CHUMCHAL72

Ok so I got tired of my old front seat center console box.



I decided I still wanted my 12 in there but I didn't want it in the front. So I figured I should be able to fit it in the back seat. And since I'm building it there that I might as well make it an armrest back there to. After measuring around I came out with this







It fit very snug as I wanted it too. The arm rest was a little low bit no big problem. The I figured that I should put some cup holders it the since there wasn't any back there anymore. Found some in the boating section at Academy. And I wanted to carpet it black. I though it was going to be really hard to carpet it. Being my first time but it was actually really easy just took my time.











I am really happy with the outcome it looks a lot better than my old center console box. Will get a pic of it installed inside the truck tomorrow.

scabcommander47

Looks good, I've been planning on making something similar this summer. What airspace and dimensions are you at?

dcs3473

Here is how my back seat center console turned out.

Wyo11Scab

iTrader: (1)

Not to dis you too bad but with a nice truck like that I would have made a box to match the interior better

dcs3473

No did at all. That was the design and look I was going for. Scares off thrives. Lol

Wyo11Scab

iTrader: (1)

You are correct. I wouldn't steal it.

Philly19111

Do you the measurements of the box i like to make one for my looks goog just what i need Thank you.

FKN3PUT

This is what I used for a rear console box with a 12" sub.

https://subthump.com/Ford-F150-Super...en66cg8la227s6

huanab

I built a similar one for myself. Don't mind the dirty truck.

FKN3PUT

That came out great, looks nice.

I'm very happy with the output, the box was the perfect size for the JL 12W3 2ohm sub I use with it.