Adjustable pots on AOEM-FRD24, anyone use?
09-21-2011, 03:44 AM
#1
Senior Member
Thread Starter
Join Date: Sep 2011
Posts: 108
Likes: 0
Received 0 Likes
on
0 Posts
Adjustable pots on AOEM-FRD24, anyone use?
Hey Guys,
I am sure a lot of us are using the AOEM-FRD24, my question is did you adjust the pots on the controller itself to boost the signal? I am asking because I just buttoned up my dash and am hoping I won't need to pull it out again and turn op the levels.
So anyone out there make any adjustments to the level pots on the AOEM-FRD24? and if so, was there a noticeable difference?
Thanks!
I am power and ground terminations away from completing one of most frustrating installs of my life!! Damn you MOLEX!!!
I am sure a lot of us are using the AOEM-FRD24, my question is did you adjust the pots on the controller itself to boost the signal? I am asking because I just buttoned up my dash and am hoping I won't need to pull it out again and turn op the levels.
So anyone out there make any adjustments to the level pots on the AOEM-FRD24? and if so, was there a noticeable difference?
Thanks!
I am power and ground terminations away from completing one of most frustrating installs of my life!! Damn you MOLEX!!!
09-23-2011, 03:30 AM
#2
Senior Member
Thread Starter
Join Date: Sep 2011
Posts: 108
Likes: 0
Received 0 Likes
on
0 Posts
Just as an FYI if anyone looks for this info. You do not need to adjust the pots on the FRD24. I had to turn my amp gains way down. If I would have adjusted the pots I am sure I would be sending my amps a clipped signal. I may check the voltage at the RCA ends to see what shows up.