2014 XLT stereo build has begun...
#12
One Clean Machine
iTrader: (5)
As thick as those rcas are, if they're not shielded well enough. Nothing will work!
#13
Senior Member
Thread Starter
sounds good to me....
with double copper braid shielding to prevent signal degradation caused by EMI and RFI interference.
Gold plated RCA male connectors
Rubber-covered, molded connector housings
99.999% pure oxygen-free copper conductor
Double shielded with copper braiding
22 pF per foot capacitance
75 ohm impedance
#14
Senior Member
iTrader: (1)
sounds good to me....
with double copper braid shielding to prevent signal degradation caused by EMI and RFI interference.
Gold plated RCA male connectors
Rubber-covered, molded connector housings
99.999% pure oxygen-free copper conductor
Double shielded with copper braiding
22 pF per foot capacitance
75 ohm impedance
with double copper braid shielding to prevent signal degradation caused by EMI and RFI interference.
Gold plated RCA male connectors
Rubber-covered, molded connector housings
99.999% pure oxygen-free copper conductor
Double shielded with copper braiding
22 pF per foot capacitance
75 ohm impedance
The following users liked this post:
freddyttt (10-26-2015)
The following users liked this post:
freddyttt (10-26-2015)
The following users liked this post:
freddyttt (10-26-2015)
#17
Senior Member
Thread Starter
Thanks everyon-. got the tool i'm gonna use to cut the 0 gauge so just waiting on some 4 Gauge Ring Terminals...
then i'll be good to go-.
tool used to cut the 0 gauge if anyone's interested.
http://www.ebay.com/itm/181898069076?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT
then i'll be good to go-.
tool used to cut the 0 gauge if anyone's interested.
http://www.ebay.com/itm/181898069076?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT
#18
Senior Member
following this. Off to a good start. Excited to see how those SD-3's perform in the FoxBox. Glad you went with the Sundown 1000D, it's an awesome little amp.
#19
Senior Member
Thread Starter
#20
Senior Member
Thread Starter
All that's left besides clean-up is hook-ups to the HU..... I wanted to put a loop in the power wire for moisture but mis-cut. also will add another screw to both grounds and lacquer them up for rust-.... oh and my loom is on it's way!