2013 FX4 Sony Nav, only adding Subs, HELP!!
#1
Senior Member
Thread Starter
2013 FX4 Sony Nav, only adding Subs, HELP!!
Hi guys I just picked up a new FX4 (pic below) and I have a terrible time with leaving things stock. I built a box for dual 12"s and I'm still deciding on which shallow mount subs to use, but in the meantime I want to get the amp mounted and wired.
My questions are:
1. Where do I tap in to add a High to Low convertor?
2. Did you guys just pull the signal from the existing sub wiring and how does that sound?
3. Did you pull it off the sony amplifer under the center console? If so, did you tap into the front, rear, or sub outputs?
And finally:
4. Did you run anything else other than a regular high-low convertor? Like an Audiocontrol unit or Cleansweep?
Thanks again guys!!
New truck:
My questions are:
1. Where do I tap in to add a High to Low convertor?
2. Did you guys just pull the signal from the existing sub wiring and how does that sound?
3. Did you pull it off the sony amplifer under the center console? If so, did you tap into the front, rear, or sub outputs?
And finally:
4. Did you run anything else other than a regular high-low convertor? Like an Audiocontrol unit or Cleansweep?
Thanks again guys!!
New truck:
#6
#8
Senior Member
Thread Starter
#9
It should be mentioned that the previous models used a dual voice coil sub. That might be why you see people with an audio control, etc. I would think that both Chanel's are the same and wouldn't be necessary to summon them.
Here's a pin out for the 2012 at the subwoofer, it might be the same, might not.
Pin1 sw1+ violet / green
Pin2 sw1- green / white
Pin3 sw2+ green / violet
Pin4 sw2- gray
Here's a pin out for the 2012 at the subwoofer, it might be the same, might not.
Pin1 sw1+ violet / green
Pin2 sw1- green / white
Pin3 sw2+ green / violet
Pin4 sw2- gray