2012 A-pillar Tweeter Wire Access
#21
Senior Member
What size is the factory tweeter in the a-pillar?
The following users liked this post:
RealRedRaider (03-02-2013)
#23
Senior Member
The following users liked this post:
BrewCityF150 (11-08-2012)
#25
If you really don't want to add a sub,and don't mind the cost go with JL Audio's C-5 components.I first just put them in the doors and replaced the tweeters in the a-pillers before adding an amp,and was amaized at the bass,loundess increase,AND clarity.The stock speakers ain't even close.For the best price check techronics.com.
#27
Mr. telephone pole
The price does kind of have that effect on ya.But Techronics.com is about $200 cheaper than everyone else.The amp i'm running is a JL XD500/3,and i'm running a 10W1V2-4 single sub.I'm also on the stock headunit till this next week when my new Pioneer AVIC-Z140BH is supposed to arrive.
The following users liked this post:
RealRedRaider (03-02-2013)
#29
Senior Member
Just installed these infinity kappa 680.9cs. Had to open the factory hole size just a but but man do they scream!!!
Attachment 161699
Attachment 161699
#30
Mr. telephone pole
I mounted my crossovers on top of the kick panels so i could get to the adjustments easier.Also to pull the a-pillar off, on the driverside pull kind of inward at the TOP and when that pops loose you will unplug the tweeter then easily pull the bottom stright back.BEFORE doing that pull the weatherstrip and the end piece of the dash out because they cover the edge of the a-pillar.On the pass. side you will pull the 2 plugs loose on the grab handle and remove the 2 screws under them (7 or 8mm)and then the same as the driverside.
Last edited by Regular Cab; 11-10-2012 at 03:40 PM.
The following users liked this post:
RealRedRaider (03-02-2013)