2012 FX4 TT SCrew w/ Sony Nav Build - JL Audio
#31
Sucks, but what are you gonna do...
In the meantime, I installed my Freedom in Motion Sync Lockpick the other night. Install went smooth, and now my boy can watch movies while we travel.
#32
Few pics from the lockpick install.
Don't be afraid to use a little force getting the airbag module out.
Install was quite simple, just a bit tidious.
I had watched the install video on YouTube for a reference and went at it.
[YouTube]zmPKuSxiBbg[/YouTube]
No need for any install tips, as it's as simple as the video makes it look.
Don't be afraid to use a little force getting the airbag module out.
Install was quite simple, just a bit tidious.
I had watched the install video on YouTube for a reference and went at it.
[YouTube]zmPKuSxiBbg[/YouTube]
No need for any install tips, as it's as simple as the video makes it look.
#34
Originally Posted by JPCharmin
nice have you played around with the lockpick yet? pretty user friendly?
Just hold the phone button for a few seconds and the prompts come up. All Yes or No answers. Press the phone button to scroll through each prompt.
#36
Senior Member
nice. I'm going to have to do this.. It would be so badass to have the rear camera on while towing the jetskis!
#37
End Result:
Signal Summing Device and Cleansweep:
JL Audio HD900/5 Amp:
Full Rear Shot:
Rear Seats in Place:
Installation Pics:
16 gauge speaker wire runs being labeled:
Sony Amp splice complete:
Labeled "Input" and "Output" for Clean Sweep Input and JL Amp Output:
Speaker wires ran under carpet behind driver's seat and into passenger sills (Input and Output runs):
Mounting HD900/5, SSI, and Cleansweep on amp rack:
Wire tuck, Wire tuck, and Wire tuck:
Signal Summing Device and Cleansweep:
JL Audio HD900/5 Amp:
Full Rear Shot:
Rear Seats in Place:
Installation Pics:
16 gauge speaker wire runs being labeled:
Sony Amp splice complete:
Labeled "Input" and "Output" for Clean Sweep Input and JL Amp Output:
Speaker wires ran under carpet behind driver's seat and into passenger sills (Input and Output runs):
Mounting HD900/5, SSI, and Cleansweep on amp rack:
Wire tuck, Wire tuck, and Wire tuck:
#39
This specific forum has got me on the right foot. For the past week I've been reading forums and watching youtube.
I'm about to do a very similar build in my 2013 ford f150 fx4 supercrew.
I want to keep my factory head unit so an interface will be needed (Audio Control LCI8, Kicker Sum 8)
I have the sony upgrade so I'm assuming the sub is under the center console. I plan to tie into the those wires since it's what you guy have done. I'm not sure if I should start another thread to provide all the details? or should I just continue to build onto this one?
I'm about to do a very similar build in my 2013 ford f150 fx4 supercrew.
I want to keep my factory head unit so an interface will be needed (Audio Control LCI8, Kicker Sum 8)
I have the sony upgrade so I'm assuming the sub is under the center console. I plan to tie into the those wires since it's what you guy have done. I'm not sure if I should start another thread to provide all the details? or should I just continue to build onto this one?