2010 Install question
#12
Car Audio Junkie
the 360.1 is fairly strait forward and very easy to install, put it wherever it will fit and run your wires to it
the 360.2 is more for audiophiles, giving you much more adjustability at a higher price, which i would say you dont need
the 360.2 is more for audiophiles, giving you much more adjustability at a higher price, which i would say you dont need
#14
Car Audio Junkie
alot of people get noise with them when the use pioneer decks, it has nothing to do with the 360 itself, pioneer decks are well known for having ground noise problems, which can be fixed by grounding out the metal casing on the rca's itself
#15
Senior Member
I would assume you have to cut off the factory plug to use the 360.1 right?
#17
Senior Member
Thread Starter
#18
The sync system uses a different signal to over ride the regular signal that would be going through the speakers when someone calls. I learned the hard way about this when I taped into the harness and than realize I had no voice sync just the sync on the screen
#19
Senior Member
You're saying it uses a non speaker level signal to drive the speakers?
#20
Senior Member
Thread Starter
I was going to tap into - not cut- the speaker wires, then run those new lines into a LOC to the amp then out to the new speakers leaving the factory wiring intact with no speakers attached to them. Am I going to loose sync this way? If so how do I keep sync?