Spicer u joint part numbers
#1
Junior Member
Thread Starter
Join Date: Feb 2016
Location: Indiana
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Spicer u joint part numbers
Am going to replace all u-joints on '91 F150 XLT Lariat, straight 6. Want to use Spicer 1310 series. I have not found a source to give me Spicer part numbers I need. Very easy to get NAPA #'s with info input, so far impossible to get Spicer #'s. Tied to the railroad track and the train's acomin'. Hep me!
#2
Senior Member
Try this http://www2.dana.com/expertforms/demenu.aspx?prod=JOI
I tried posting a screenshot, but it wont let me.
I tried posting a screenshot, but it wont let me.
Last edited by svt2205; 02-10-2016 at 01:33 AM.
#3
Senior Member
Check out rockauto. Best catalog and usually the cheapest.
#5
Junior Member
Thread Starter
Join Date: Feb 2016
Location: Indiana
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Thank you all for your help. However, I've tried these sites and am confused by them. The Dana diagram shows the passenger side front axle inner as different from the outers on both sides. NAPA says all 3 are the same. And I don't understand the 'Exc. U-bolts, w/U-Bolts' or 'lub fitting in brg. cap', so... And rockauto has me equally confused. So, maybe a dummy, but a confused one. Right now I have a buddy at Carquest doing some research for me but have to get with him today and see what he came up with and will all depend. I may just have to go with another type because of the confusion. Also, if time permits, I will try to talk to the Ford rep on the Dana site and see. As I understand it, OEM is Spicer??
#6
Senior Member
Thank you all for your help. However, I've tried these sites and am confused by them. The Dana diagram shows the passenger side front axle inner as different from the outers on both sides. NAPA says all 3 are the same. And I don't understand the 'Exc. U-bolts, w/U-Bolts' or 'lub fitting in brg. cap', so... And rockauto has me equally confused. So, maybe a dummy, but a confused one. Right now I have a buddy at Carquest doing some research for me but have to get with him today and see what he came up with and will all depend. I may just have to go with another type because of the confusion. Also, if time permits, I will try to talk to the Ford rep on the Dana site and see. As I understand it, OEM is Spicer??
Trending Topics
#8
Junior Member
Thread Starter
Join Date: Feb 2016
Location: Indiana
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
I did not get that diagram from the link--but I need 3 for front axles (yes, part time 4WD with auto locks out getting changed to Warn prem manual, 2 for front drive shaft and 2 for back. It is a '91 and catalog in your post cuts out above it. But from diagram, I need all of them from drawing Y. I am wanting zerks for lub but probably not in bearing cap?? So essentially, I need #'s for those in Y that are greasable. I do have 5 speed but not sure it's HD. Not sure how to tell about that?