Rear bumper on brand new truck isnt right
#1
Rear bumper on brand new truck isnt right
Drivers side is about 1/2" further from bed than passenger side . I know I'm **** retentive but I'm not happy with this for being a $50k truck .
Should I have dealer order new bumper?
Should I have dealer order new bumper?
The following users liked this post:
LawIns2 (09-01-2014)
The following users liked this post:
LawIns2 (09-01-2014)
Trending Topics
#8
My rear was 1/4" low on the passenger side, and my front was off to the driver side about 1/4".
I took it in and the dealer the adjusted them for me without a problem. Even washed the truck, and gave me a rental while they had it.
I took it in and the dealer the adjusted them for me without a problem. Even washed the truck, and gave me a rental while they had it.
The following users liked this post:
LawIns2 (09-02-2014)
#9
Member
My bed sits about 1/2" high on one side, makes the whole truck look funky looking straight at it from behind. Not a big deal.
#10
Senior Member
Not hard to do if you have the right tools and shop setup. If you have a good dealer it might be okay to have them do it. There is more than one dealer near me that I would never let touch my vehicles. For anything.
I had to adjust rear fender out about half an inch. Didn't notice it until I put mud flaps on. Then it was very noticeable looking from rear and comparing flap to tire alignment from one side to the other. Loosen one bolt, pull, tighten, done.
I had to adjust rear fender out about half an inch. Didn't notice it until I put mud flaps on. Then it was very noticeable looking from rear and comparing flap to tire alignment from one side to the other. Loosen one bolt, pull, tighten, done.
Last edited by depami; 09-02-2014 at 08:06 AM.