You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, so please join our community today!
I was going to have Line-X professionally done, but am pretty broke right now, so decided on a Raptor DIY kit for my Bronco’s tub. If it turns out as good as I think it will, the F150 will be next. I hear this stuff is pretty easy to apply and I’m taking my time with the prep. Temperature outside right now is in the low ‘70’s with low humidity, so I’m ready to rock. Any last tips or tricks you folks know about applying Raptor?
How can anyone be anti-Bronco? Arent there laws against that? There should be. I always wanted a Bronco made out of a diesel Excursion.
I wish I could help with the bed liner. I used one on my buddy's Ranger about 15 years ago but looking back now I htink it was the prep work we did (Or really didnt do) that made it turn out hobbible. I hope it goes well for you.
Tbh I never used it, But read some reviews and most of them were good. And I actually have it booked-marked for when I get some extra money, I can buy it and try it for myself. But it would be going in my 78 f150. So hopefully it will do you well, if so let us know.
How can anyone be anti-Bronco? Arent there laws against that? There should be...
That's pretty funny, but fortunately not necessary. Early Broncos rock!
I got all the grinding and sanding done yesterday. Today the masking, primer on any bare metal and maybe the first coat if I don't get too many distractions
Unfortunately, my response comes after the fact. However, for those about to do a spray-in bedliner install be aware that proper surface preparation can never be overstressed. Sanding/scuffing the paint surface is very important so the coating will adhere. Doing a good job takes much time and labor. You can use an abrasive "cup brush" mounted to a drill to make the job go much quicker and easier. http://alsliner.com/cupbrush
U-POL Raptor - Tell me your tips and tricks
C'mon guys give me some... 
Linear Mode
