Blower not working
12-01-2014, 09:22 AM
#1
Blower not working
Good day all,
I have a 2010 Platinum. My blower went out a few months ago I replaced the relay worked fine for a while and it went out again. So I replaced the resistor and it has worked for a while and stopped the other day. I swapped out the relay to check it no change. A senior member said to check the ground wire at the connection and clean it. I did check for power at the connection (resistor)and tha seemed to be good (power) i just can't tell if the resistor is bad or if the blower motor itself has gone bad. Seems to early for a bad motor or anything for that matter. i would suspect the control switch, but its push button or touch screen. Need one of you guru's to advise.
Thanks,
AEC USN (Ret)
I have a 2010 Platinum. My blower went out a few months ago I replaced the relay worked fine for a while and it went out again. So I replaced the resistor and it has worked for a while and stopped the other day. I swapped out the relay to check it no change. A senior member said to check the ground wire at the connection and clean it. I did check for power at the connection (resistor)and tha seemed to be good (power) i just can't tell if the resistor is bad or if the blower motor itself has gone bad. Seems to early for a bad motor or anything for that matter. i would suspect the control switch, but its push button or touch screen. Need one of you guru's to advise.
Thanks,
AEC USN (Ret)
12-01-2014, 09:26 AM
#2
Mark
iTrader: (1)
read power at the motor...
