alsatropine

iTrader: (2)

Oh yeah.. man i wish i would have known that. Check your bearings and racers in the rotor. Regrease them before you reinstall. Makes it a little easier.

Prof

I haven't torn anything down yet, was just about to turn my first bolt when I saw this...sorry I didn't explain that this was a 2wd.

Last month I has the front bearings replaced along with the rotors (as the rotors had previously been ground and were so thin they couldn't be faced again) so my mech replaced the whole hub assembly. So those are new...anything I should/should not do here? This was on of the reasons I did not want to remove the assembly if I could help it...

alsatropine

iTrader: (2)

Sorry didnt see the response. You have to pull it. Its no big deal. Just watch which way they come off.