Blend Door Actuator Motor
11-10-2014, 01:30 PM
#1
Junior Member
Thread Starter
Join Date: Oct 2014
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Blend Door Actuator Motor
So I picked up my actuator motor and am ready to install it but have a question for those who have installed one themselves. Do I need to match the alignment of the gear to where it was when it went out, or simply make sure my temp control **** is turned all the way to the left or cold position and put it in? I know from my research so far its not going to be fun getting those screws in or out, so I want to make sure I only have to remove and install it once! Thanks in advance for the assistance.
