Alarm Tripped: Remote Start Not Working
#1
Alarm Tripped: Remote Start Not Working
I've search the forum and Google and can't find an answer. The remote start on my 2013 Platinum stopped working. I have read that tripping the alarm (which I did) will cut off the remove start. How can it be reset?
#2
Member
Did you trip the alarm opening the hood? If so disconnect the hood switch (driver fender) and reconnect it, close the hood and lock the truck with the fob and try to remote start it.
#4
Member
The following users liked this post:
Flintlock50cal (01-03-2015)
#5
#6
Well, it didn't work. I disconnect the battery for about 30 minutes and made sure everything else work after reconnecting it. I started the engine, put it gear, shut it off and locked the doors. No remote start.
#7
Member
Is or was your check engine light on recently? Remote start is disabled if so, other than that I'm out of ideas.
Trending Topics
#9
Member
There ya go, need to clear the code then remote start will operate again, at least until it sets a code again.