2016 F150 driver window switch / glitch ???
09-24-2016, 01:26 PM
#1
2016 F150 driver window switch / glitch ???
hey guys I'm new to the forum and I have tried to search this problem and could not find any resolution. I have attached a video that explains my issue.
09-24-2016, 07:54 PM
#3
09-25-2016, 07:06 AM
#5
I don't have in-Channel visors and this occurred driving off the lot. It happens only when I hit the window switch 3-5 "up" and "down" amount of times. There's nothing in the way of the window. I'll try to do what the video suggests and report back in 48 hours. Thanks !
09-25-2016, 07:19 AM
#6
Senior Member
I couldn't tell in your video if they were in-channel or not.
On my 2013 in the owners manual are instructions on how to recalibrate the window. Look in your manual it may have more specific instructions. If it doesn't correct the issue then I would take it to dealer that's what the warranty is for. See below.
Restoring the One-Touch Up Functionality
Note: Perform one-touch up re-calibration with the door closed.
Calibrating with the door open will cause the window to continuously
bounce back.
Functionality may be lost under low battery power conditions.
To reset this function after restoring full battery power:
1. Pull the switch to the one-touch up position.
2. Hold the switch until the glass reaches the stall position and continue
to hold for two seconds.
3. Press the switch down and operate the window to the full down
position. One-touch up will now be functional.
Bounce-Back (One-Touch Up or Down Windows Only)
The window will stop automatically while closing and reverse some
distance if there is an obstacle in the way.
Overriding the Bounce-Back Feature
WARNING: When you override the bounce-back feature the
window will not reverse if it detects an obstacle. Take care when
closing the windows to avoid personal injury.
Pull up the window switch and hold within two seconds of the window
reaching the bounce-back position. The window will travel up with no
bounce-back protection. The window will stop if you release the switch
before the window is fully closed.
On my 2013 in the owners manual are instructions on how to recalibrate the window. Look in your manual it may have more specific instructions. If it doesn't correct the issue then I would take it to dealer that's what the warranty is for. See below.
Restoring the One-Touch Up Functionality
Note: Perform one-touch up re-calibration with the door closed.
Calibrating with the door open will cause the window to continuously
bounce back.
Functionality may be lost under low battery power conditions.
To reset this function after restoring full battery power:
1. Pull the switch to the one-touch up position.
2. Hold the switch until the glass reaches the stall position and continue
to hold for two seconds.
3. Press the switch down and operate the window to the full down
position. One-touch up will now be functional.
Bounce-Back (One-Touch Up or Down Windows Only)
The window will stop automatically while closing and reverse some
distance if there is an obstacle in the way.
Overriding the Bounce-Back Feature
WARNING: When you override the bounce-back feature the
window will not reverse if it detects an obstacle. Take care when
closing the windows to avoid personal injury.
Pull up the window switch and hold within two seconds of the window
reaching the bounce-back position. The window will travel up with no
bounce-back protection. The window will stop if you release the switch
before the window is fully closed.
Last edited by Effex 2; 09-25-2016 at 07:21 AM.