06 Lariat soft pedal after pads changed
#1
Junior Member
Thread Starter
06 Lariat soft pedal after pads changed
Just changed my front pads on my 06 Lariat crew cab and now have a soft pedal. Did not open any lines or bleeder valves. I did pump the pedal between doing each side and had a good pedal but when I crank the engine I get a soft pedal. No codes showing up. What can I do? What did I do wrong ? I have looked for an answer all over this blog but cannot find one with the same problem.
#4
Carefully inspect all the brake lines for leaks, soft spots & cracking in the rubber sections.
If the lines check out good-
Get a mityvac http://www.mityvac.com/pages/products_hvpo.asp & change the brake fluid. Brake fluid absorbs moisture & over time becomes less effective. Unless there is some other issue in your brake system, this will give you a better feel in the pedal.
If the lines check out good-
Get a mityvac http://www.mityvac.com/pages/products_hvpo.asp & change the brake fluid. Brake fluid absorbs moisture & over time becomes less effective. Unless there is some other issue in your brake system, this will give you a better feel in the pedal.
#5
Member
If you have 4 wheel abs you need to do a service bleed on the HCU. Have to use a scan tool with that option. I've seen some cheap ones on ebay but can't vouch for any other than a genuine Ford VCM or NGS.
.
.
#6
Junior Member
Thread Starter
Thanks Rnolcomp. I done plenty of brake jobs in my time but have run across two of these recently with 4 wheel ABS. I have a Innova Equs 3140 scan tool will it do this ? Thanks for your help. I'm not on a computer often because of my job.
#7
Member
Not familiar with that brand scan tool.
.
Trending Topics
#8
Junior Member
Thread Starter
Just checked it and the innova 3140 doesn't have abs capability. Over the last few days the pedal had tightened up a little. I maintain/pm my vehicles so there are no leaks or broken lines or stuck calipers. Must be the ABS is overiding the function.
#9
Having the same issue due to doing the same brake job steps (never opened the system just pushed the pistons back) Pedal has been very soft for 3 days now with no sign of improvement. What was the fix? I dont have the scan tool and trying to avoid a trip to the dealer. Thanks for the info!