Home Made Front Bumper - pic heavy
#13
Senior Member
Thread Starter
A tiny bit of progress today:
Last edited by STingray1300; 01-15-2017 at 01:49 AM.
#14
Senior Member
Thread Starter
Can you see the minimal changes today?
#16
Senior Member
Thread Starter
Attached the last bits of the skin today. Next will be the push guard mounts, lower edge stiffener, then getting it smoothed out and getting it ready to spray (bed liner).
#18
Senior Member
Thread Starter
My Warn Zeon10 winch (removable). I never wanted to just drive around everywhere with it, and the EcoBoost's air flow to the CAC would be impacted if I did, so, it will be removable and will ride in the bed of the truck with the tool dept.
No pictures today. I removed the bumper and am scrapping it... <just kidding> No, it is time to do some finishing touches, like install an edge stiffener along the bottom edge of the skin (for lateral strength), and install the push guard/light mount bracketing to the bumper.
I've already done a preliminary grind on "Frankenbumper", and it's starting to look pretty good. I won't be mounting it back on the truck until after it's been sprayed with truck bed liner.
No pictures today. I removed the bumper and am scrapping it... <just kidding> No, it is time to do some finishing touches, like install an edge stiffener along the bottom edge of the skin (for lateral strength), and install the push guard/light mount bracketing to the bumper.
I've already done a preliminary grind on "Frankenbumper", and it's starting to look pretty good. I won't be mounting it back on the truck until after it's been sprayed with truck bed liner.
Last edited by STingray1300; 01-18-2017 at 12:25 AM.
#20
WOW can't wait to see what it looks like all sprayed and back on the truck It looked sharp already