2010njlariat

I put a 17 raptor third brakelight on my 16 xlt. My question is...I'm not using the 4th wire because it's the running light for the leds to come in with the parking lights. Do you have any idea where I can tap the wire to?

go-on3

I found that the directions from Dynamic Dynamics weren't accurate when I was installing my retro fitted lights and found this when I was searching. . Hopen this helps, good luck !

2010njlariat

I can do it but I'm not the best with wiring...some guidance on how to get the wires up front especially with the dual moonroof would be appreciated from someone also!

And any way to tap under the dash if I can get the wire to that location

2010njlariat

Any other suggestions?

cwcb08

does anyone have the headlight schematics handy, specifically for the parking lights on an XLT

i want to know what fuse goes hot when they come on or what else they tie into that i could tap

tmcolegr

The headlamps receive 12V + from the BCM - not a fuse(s)

B-ManFX4

Any chance you can post the same for factory LED headlights ?

cwcb08

just grabbed this from another thread and posting here ( its parking lights without LED ),
WHY DO ALL THE DAM LIGHTS NEED TO BE CONTROLLED RIGHT FROM THE BCM!

cwcb08

found this website its not complete with all diagrams and only lists 2015 but it gives an idea: http://revbase.com/BBBMotor/Wd

2010njlariat

So 15+ changed and I can't utilize any wire inside/around the truck?