swapped manual fold tow mirrors for power fold/extend - not working
#1
Senior Member
Thread Starter
swapped manual fold tow mirrors for power fold/extend - not working
What did I miss? 2015 XLT.
I purchased power extend/fold tow mirrors from someone on this forum and purchased the correct switch from TASCA. Put it all together and power fold/extend does not work.
I don't think I have the wrong mirrors as the 22 pin connector is almost fully populated where-as my manual fold mirrors was not.
Does this require programming? If so, how?
Hopefully, this is simple and I just did something wrong. All the rest of the features, power glass, spot, heat, puddle work.
I push the fold/extend button so the light is on. I then use the joypad down for fold and nothing happens. I use the joypad left or right and nothing happens.
I purchased power extend/fold tow mirrors from someone on this forum and purchased the correct switch from TASCA. Put it all together and power fold/extend does not work.
I don't think I have the wrong mirrors as the 22 pin connector is almost fully populated where-as my manual fold mirrors was not.
Does this require programming? If so, how?
Hopefully, this is simple and I just did something wrong. All the rest of the features, power glass, spot, heat, puddle work.
I push the fold/extend button so the light is on. I then use the joypad down for fold and nothing happens. I use the joypad left or right and nothing happens.
#2
Senior Member
I'm sure its possible go to the dealer ask them to program and see if it works. I know if you install the OEM brake controller in to the factory harness it will not work until you have it programmed by the dealer.
#3
Senior Member
I checked into doing this a while back and was told that you need to get it re programmed at the dealer when install is complete.
#4
Senior Member
Thread Starter
Does anyone have actual experience? Reading through the various mirror threads, no one has said programming is required except in the case of swapping from a 8 wire harness to a 22 pin harness.
#5
I'm guessing you swapped the harness?? There is a relay for the extended mirror part so I would say your truck is missing that. For them to fold you probably have to get the door modules reprogrammed.....good luck
Trending Topics
#8
Senior Member
Thread Starter
If you work for Ford, I might think you could have some inside knowledge to know what my next step should be.
Is a reprogram of the door modules required? If so, how?
Is a reprogram of the door modules required? If so, how?
#9
#10
I've never done a mirror swap like that but if all the wiring is there then I would say all you need to do reprogram the modules. There is a relay for the extended mirror part & I'm sure your truck doesn't have it, it might not have the wiring running from the bjb but I'm not sure.