logan1014

Hey guys I hope you can help me. I have a 2015 scab sport 4x4. I want to do a level and was wondering about offsets and if i can put 35x12.50 on there. I have searched and seen people doing it with factory wheels but im getting aftermarket ones. I do like them to stic out a little and wheels i have found i liked are +15 +10 and 0 offset. I Have a 2.5" level for the truck now. Thanks in advance

logan1014

Anything ?

ExpresswayFord

Offsets are irrelevant unless you also tell us the width of the rim.
To fit a 35x12.50, you can't have it sticking out too far, or else you'll have problems with rubbing.


I would recommend a 9" wide rim with +18 or higher offset. +15 or +12 might work, but I can guarantee you'll have problems with 0 offset on a 9" rim.

bign1497

I don't think you can fit too many 35" combinations without rubbing or trimming. I would recommend 33x12.50. I think you would have better performance and mileage results. Check out this set up.https://www.customwheeloffset.com/wh...it-custom-rims

2015PLATINUM4X

I went 20 x 9 +20 with 285/65/20 (approx 34.5x11.50) and the rough country level. Truck is due in next week. From all of the posts I reviewed this seems to work well without rubbing.

Sportsman949

I have a 2011 and put a 2 1/2 leveler and have 35x10.5x 20's on it. But I have stock wheels and they have 74.000. Miles now in them and going strong. No front end or alignment problems I can see so far.

logan1014

Sorry guys. Most wheels I've found are 20x9. And 18 offset or 12. I'd really like the +12 or less. I've read about crash bars but mine doesn't have them I don't think. Any help would be appreciated

ExpresswayFord

Just the SuperCrew has the crash bars.

RyanCZiegler

Hey sorry... Not to High Jack this thread but if I did want to go with a 33" 275/70r18 ko2 without any lift or level, would it fit? What if I added 1.5" spacers? Would it still fit? Other than the speedo being slightly off, would the truck still run fine and shift fine? Thanks! SCab 3.5 EB 3.55 Rear

ExpresswayFord

33's will fit on a stock sCab 4x4. Is yours a 4x4?
Spacers will make them not fit at stock height, you'd need a level.
Truck will run and shift fine, it's only 1" taller than stock.