Retrofit Power Fold Tow Mirrors to XLT
#491
Here it is in both JPEG & pdf format
#494
If anyone needs anything else just let me know. (100/0)
#495
Originally Posted by priemer93
Sorry for the delay and bad pictures, when I'm getting it done I don't think about pictures hah. But I wired the telescoping last week and that's all it took to work. As stated above, ran 2 wires on drivers side to connect to the new lariat harness through firewall to connector right on top of the engine bay on driver side. This side was pretty easy. Passenger side is short, again 2 wires going from new lariat harness connection, to the connector which is up underneath the passenger dash. You can see which connector it is in the picture, but it is the furthest one up on the firewall, and barely can get to it. But I just siliconed all my wires into the spots since no direct connector pins yet.
Attachment 425774
Attachment 425774
#496
Senior Member
do you have diagrams of all wires in the mirrors, in the add puddle light thread someone said they couldn't find out why the signal led had a 3 wires connector while only two pins are used ( standard xlt 302a mirrors - heat, power glass, turn, auto dim )
#497
The following 2 users liked this post by tmcolegr:
jd50i (12-20-2016),
TroyThibodeaux (01-09-2021)
#498
Trailer Tow Extend & Retract Wiring Diagram
The following users liked this post:
jd50i (12-20-2016)
#499
Senior Member
Not wanting to be greedy but do you have the connector pin outs as well? Specifically the 8 pin harness
Last edited by cwcb08; 12-20-2016 at 10:34 AM.
#500