Has anyone added oem fender flares?
#1
Senior Member
Thread Starter
Has anyone added oem fender flares?
If you can really even call them that. I'm just wondering if they need 3m tape or do they just attach with push pins and screws?
Are the sold by Ford already painted?
Something like this is what I'm talking about.
http://www.ebay.com/itm/2015-F-150-O...dVLWui&vxp=mtr
Are the sold by Ford already painted?
Something like this is what I'm talking about.
http://www.ebay.com/itm/2015-F-150-O...dVLWui&vxp=mtr
#3
The following users liked this post:
Leadfootguy (01-11-2021)
#4
Senior Member
Thread Starter
So I have one saying they'll fit and one saying they won't. Redalty, they look good.
Gentz, why do say they won't fit? I'm assuming the push pins just mount into the plastic wheel well liner and not the aluminum fender. Then again, maybe I'm worng.
Gentz, why do say they won't fit? I'm assuming the push pins just mount into the plastic wheel well liner and not the aluminum fender. Then again, maybe I'm worng.
The following users liked this post:
mdomicolo (01-31-2023)
The following users liked this post:
mdomicolo (01-31-2023)
#7
Thanks,
Doug
Trending Topics
The following users liked this post:
mdomicolo (01-31-2023)
#9
alright so they will fit IF you cut all the pins/clips off the back of the flares like stated above. If your looking for something you can take out of the box and double sided tape/ clip on then these will not be the route you want to take. sorry I could have made that clearer in the beginning.
#10
Junior Member
I did this slight adjustment to my clips for my 2013 XLT I had. Only thing you have to make sure of when you cut the pin off is that when you put the double sided tape on, make sure it looks like the surface of the tape sticks out as far as the edge of the fender flare. On my 2013, I only need one piece of tape. I assume the 2015's would be the same, but maybe you might need two pieces of tape on top of each other to get the correct height. The only holes I drilled were for the push pins that go in the plastic front bumper and the holes for the part of the fender flair that goes into the wheel well. FYI, if you have rear wheel well liners, it gets a little tricky, but not too bad.
The following 4 users liked this post by Ruby13F150: