ComieHook

Hey guys, I have a 3-speed manual tranny that I am going to be installing, but I have a problem. Take a look at the attached picture. I need the small round cover plate that allows the speedometer cable to be installed. I don't even know what it is called, which would help a lot. And maybe someone knows where I could find one?
Thanks!
Harold

whomrig

I think that is called the speedometer gear housing. it is more than a cover plate.

ComieHook

Yes sir it is. But take a look at this picture that I found online. It shows a cover over the hole, with the speedometer attachment in the middle. Is that all one piece?
Thanks!
Harold

bubbabud

It is one piece it has an "O" ring to seal it to the transmission and is held in place by a clamp and cap screw the speedo gear slips in side and has a square hole in the end to mate with the speedo cable. there are several gears available with different tooth count to match tire size and gear ratio. also different pitch depending if it goes in above or below the output shaft.

ComieHook

Thanks bubbabud! Any idea what it might be called?
Harold

bubbabud

speedometer driven gear housing.