Disconnecting Line at Slave Cylinder
02-22-2016, 10:40 PM
#1
Member
Thread Starter
Disconnecting Line at Slave Cylinder
It's on my '95 with 300 6 cyl and M50D R2 trans. I'm pulling the trans to replace the clutch and the master/slave cylinders.
I suppose I could remove the entire master/slave assembly with the trans? The new assemblies come with the line disconnected. How are they attached?
I have a service manual on the way, but I'd like to get the ball rolling.
I suppose I could remove the entire master/slave assembly with the trans? The new assemblies come with the line disconnected. How are they attached?
I have a service manual on the way, but I'd like to get the ball rolling.
