cgossett

let's see
220 for the box (motor craft)
25 for the high pressure hose
150 for the tie rods
8 bucks for fluid (guess)

so about 400 bucks i guess

cgossett

wasn't bad. i didn't do the ends, i did the inners. it was a bit of a pain getting the pitman arm off the steering box, but the rest was pretty straight forward. Need to get an alignment yet. if you need any advice ask. Make sure you can get your high and low pressure lines etc while you're at it, because if they're rusty they might break when you drop your old box. good luck.

f150cam

about 90% done unless i decide to do something on the plate (drawing of some sort) plate needs to be polished still, it has no shine to it at all.

Full-boost21

Installed a 4" MAF adapter and a K&N cone filter. Then ordered flex pipe and V-Band flanges for the header flange/ Y pipe.

dirtcrew51m

Replaced front tank and fuel pump.

LOCO LAPTOP

Radiator support gone. after a few good kicks. :p


The 2 bottom bolts that attach it to the frame are still there. I will need to cut them off.

cgossett

U r missing your engine

chocolateskwlbuss

Built her a sub box for a 4ohm 8" kicker

LOCO LAPTOP

Yes, doing a 347 stroker.

7700SCREW

Removed my headache rack and replaced it with my other tool box.
Also removed my "cut" bumper and installed my chrome bumper.