Truck Shut off while driving
#12
Member
Thread Starter
Join Date: Jul 2012
Location: Charlotte, NC
Posts: 50
Likes: 0
Received 0 Likes
on
0 Posts
Got it to throw a code last night, I tried to drive it seeing as it has started every time I go out to start and let it run. It stalled after a mile. Would not turn over for about 10 minutes than it turned over and I tried to head back home and it stalled out 5 seconds later but atleast this time I was able to get into a parking lot. I let it sit for a few mins and it fired so I got moving and the light came on. Pulled the code when I got home today and its a P0320. I had this code before I had the pump replaced, I told the shop about the code but they insisted it was the pump.
I got my parts in today and I just put on the ignition coil, I had my shop(not the same one that replaced pump) price out them replacing the plugs, wires and distributor and they quoted me a nice deal and they are going to look and see if its something else and get my tank to stop leaking gas when its about 3/4 a tank or more. Hoping we figure it out. I miss driving it.
I got my parts in today and I just put on the ignition coil, I had my shop(not the same one that replaced pump) price out them replacing the plugs, wires and distributor and they quoted me a nice deal and they are going to look and see if its something else and get my tank to stop leaking gas when its about 3/4 a tank or more. Hoping we figure it out. I miss driving it.
#15
Member
Thread Starter
Join Date: Jul 2012
Location: Charlotte, NC
Posts: 50
Likes: 0
Received 0 Likes
on
0 Posts
You're advice was and is appreciated and from all the looking up I did it seems like a common consensus. I planned to replace these items anyway, it would be great if they were the cause. I have a buddy coming over tomorrow after I finish my 12hr shift and we are going to change out everything, will save me the 50 the shop was going to charge. We'll see what happens
#16
Member
Thread Starter
Join Date: Jul 2012
Location: Charlotte, NC
Posts: 50
Likes: 0
Received 0 Likes
on
0 Posts
Finally got it "buttoned" down today. Took it for a spin and noticed the timing was still off, so got back home and my buddy and I got it right. Took out again for a 30 min trip, nothing happened, drove fine although I was worried the whole time. So I believe we got it, we erased the code and I just got back from driving it a tad more. Seems to be good now, keeping fingers crossed.