grthayer

K. so i just bought a brand new shortblock. i wanna put gt40 heads, and a nice camshft with good sound and torque. will i need to change anything for the heads to work. how big of a cam can i go with the stock valve train?

dr_bowtie

you have to be careful if you go too big on the heads and cam you'll kill your bottom end torque....

stay conservative on the cam...shorter duration cams make more low end torque...

dirtcrew51m

Also with big heads and cam, you might need mass air if you do not have it.

grthayer

how about the lunati voodoo cam. do they do well and give good sound? i want some chop at idle. i wasted my money on the comp extreme 4x4 cam. it didnt do **** for me. sound or power. the voodoo cam im looking at has 262 Adv. duration and a 499 gross lift. 1400-5800 rpm range. would that be to big for the gt40 heads(springs). another question, would the b303 cam work. a 351 is just a 302 stroked out right? thanks fellas.

dr_bowtie

what is it going in...? carb or EFI?

carb no problem....EFI you will need custom programing or a stand alone ECM....

problem is when you raise the duration you also raise the power curve...IE: the point in which the cam starts making good power...you'll need to get the engine into this range to make it go...so you'll need more converter and rear gear for an automatic or higher clutch release rpm and rear gear for a stick shift...

Sounding good can mean other mods else where....rumpity rump is fine but if you dont do everything so it all works together it will be a turd...and a mushy turd at that

tleach17

351 is bored and stroked over 302. I believe you need a stroker kit and .030" bore to make a 347 out of a 302. But dontquote me on that.

grthayer

its goin in a 1991 f150 efi. its gonna be mud boggin most the time. just the weekends is the only time ill drive it. whats the biggest lift cam i can run and be safe with the 351 with gt40 heads? thanks