At a loss with codes
#1
Uzi does it!
Thread Starter
At a loss with codes
So my dad was driving my truck back from work and he felt a clunk and the check engine light came on, and the engine shut off. He was able to get it started after a few minutes, so I pulled codes and got this:
I'm completely lost. Over the passed few weeks I have replaced the header gaskets, drive shaft u-joints, and done some dash work. The truck is a 1996 5.0 auto withe obd2. Thanks!
I'm completely lost. Over the passed few weeks I have replaced the header gaskets, drive shaft u-joints, and done some dash work. The truck is a 1996 5.0 auto withe obd2. Thanks!
#2
Senior Member
I would start by tracing any ignition wires to make sure there is no physical damage. After that i would check for any shorts and start looking at how to test the sensors for proper function. This should give you a start.
engine-codes.com/p0320_ford.html
engine-codes.com/p0320_ford.html
Trending Topics
#9
Uzi does it!
Thread Starter
So here's what the engine-codes site said:
- Engine Light ON (or Service Engine Soon Warning Light)
- Lack/Loss of Power
- The engine may be harder to start
- The engine may stumble or stall
It has been doing all of these, and I think that the clunking is more of a stumbling.
- Engine Light ON (or Service Engine Soon Warning Light)
- Lack/Loss of Power
- The engine may be harder to start
- The engine may stumble or stall
It has been doing all of these, and I think that the clunking is more of a stumbling.