Not getting codes
#1
Not getting codes
Hello guy/ maybe gals too
first post I own a 1992 f150 5.8 efi xlt and the check engine light is on and I've tried using the paperclip but the check engine light just stays on while trying to do the koeo and I'm not getting any where with it I've checked wires and plugs the paperclip sits in the spots fine.
I have looked at the diagram from other post on where to put the paperclip and it' in the correct spots I'm a little worried
first post I own a 1992 f150 5.8 efi xlt and the check engine light is on and I've tried using the paperclip but the check engine light just stays on while trying to do the koeo and I'm not getting any where with it I've checked wires and plugs the paperclip sits in the spots fine.
I have looked at the diagram from other post on where to put the paperclip and it' in the correct spots I'm a little worried
#4
Old Timer
#6
does the code reader even start the test? you should hear actuators click and the code reader should show 000. If the code reader can't even communicate with the truck you may have problems with the connector, etc. If the code reader does start the test and you can't get any codes, not a "111" or anything, then you may very well have a dead ecc/ pcm/ computer. I just went through this exact thing. BTW: most FLAP's can't read OBD1 codes.
#7
No I plug the code reader in to the ecc connctor turn the key on engine off and turn code reader on press the test /hold button and nothing happens it said u have to get the truck to operating temps I can' keep my truck running long enough to start warming up the block could that stop it from wanting to start a test
Trending Topics
#8
It will run a KOEO test on a cold engine. That is not what is preventing you from doing the test. I wish I could help more. Search for "OBD1 scanner can not communicate with the ecc/ pcm/ computer" and you should find more info.
#9
Old Timer
Also "Check the single test connector for voltage, it should be 5 vdc."
If you don't have this 5vdc on that single pin connector, the Test will not start, and your Reader will not work.
Last edited by vjsimone; 10-30-2017 at 09:52 AM.
#10
Yes the code reader turns on and shows 000 then I press the test button and nothing happens I will check the single grey port for the 5 volt if its not a 5 volts what can I do to fix it so I can read these codes.. i miss driving my V8